Safety Tip: Critical Lift Plans

A critical lift needs a plan before the hook moves Dropped loads are rare, but even one is too many. On vessel decks, in drydock and in plant bays, a load that comes down can hurt or kill the people below and wreck equipment. Signal Mutual, which writes safety guidance for shipyard and waterfront employers, […]

Safety Tip: Sling Inspection Criteria

Check every sling before it takes the load Every sling gets a look before every lift. On a vessel deck, in drydock or on a plant floor, you are the last check before the load goes up, and Signal Mutual says that inspection is your job. The Occupational Safety and Health Administration (OSHA) requires shipyard […]

Safety Tip: Signs of Heat Illness

Know the warning signs in yourself and your crew Heat illness can come on fast, and the person it hits may not be able to say so. Steel decks, engine rooms and closed compartments hold heat and trap it, according to Signal Mutual. The Occupational Safety and Health Administration (OSHA) says over 70 percent of […]

Straight Talk on Staffing: What 30 Years in Skilled Trades Staffing Has Taught Us

Over the course of this series, we have covered a lot of ground. Ghosting. Turnover. Bad placements. Time to fill. Unqualified applicants. The mechanics of a traveling workforce. The difference between a specialist and a generalist.  On the surface, these read like eight separate problems. In practice, they are almost always one problem showing up […]

Safety Tip: Mental Health

The trades take a toll you cannot always see  The trades have a strong physical safety culture. Hard hats, harnesses, steel-toed boots – we talk about protecting workers’ bodies all the time. But there is a hazard that does not get the same attention, and the numbers show it is costing more lives than most […]

Safety Tip: Fatal Four – Caught-In or Between

The equipment does not stop – you need to stay out of its path  OSHA Fatal Four: Caught-in or -between accidents occur when a worker is crushed, squeezed, or compressed between objects. These cause traumatic amputations, crush injuries, and fatalities.  Caught-in/between hazards exist wherever moving machinery, heavy equipment, and structural components operate near workers. The […]

Translate »